The only thing this bill seems to affect are apps. It has no provision for websites, meaning kids would still have unlimited access to adult content. If a kid wants to get around browser checks, all they have to do is either install an older browser that doesn’t use the OS verification, or find a plug-in that fakes it (and of course those will immediately come out).

Even worse, if the OS requires ALL software to acknowledge the age verification checks, what do you think that means? Everyone in Colorado is required to immediately spend thousands to buy all new versions of every program they use? And what happens to the software that is no longer updated? If you’re lucky, you can buy something completely different and spend months rebuilding all your old information into the new system? Sounds wonderful.

Where did you get this from? Sounds like more of the crap from DOGE where Musk had no clue how computers work so he just assumed that everyone listed in SSI was getting automatically paid.

Honestly, are there any HDDs that can really reach 6gb/s speeds? I haven’t seen any that could reach 3gb/s. My current array is all running on SATA-2 backplanes, but with 8 drives in the raid it clocks out at 460MB/s sustained (bytes, not bits). Considering my previous NAS could barely reach 70MB/s on a 6-disk array, I was quite pleased with the new setup.

Your server needs to have a static IP address. Once you have that, and have your DNS service set up, then you should be able to update your domain(s) to point to the new DNS. This new server doesn’t have to be your primary DNS entry for the domain(s), but it should be one of the first two entries. And that’s pretty much all you need to get started.

One other consideration is setting up the master/slave status of your DNS servers so you only have to make updates in one spot (helpful to ensure everything stays in sync). This isn’t a requirement, it just makes your life easier.

I still think rear signaling could be improved dramatically by using a wide third-brake light to show the intensity of braking.

For example – I have seen some aftermarket turn signals which are bars the width of the vehicle, and show a “moving” signal starting in the center and then progressing towards the outer edge of the vehicle.

So now take that idea for brake. When you barely have your foot on the brake pedal, it would light a couple lights in the center of your brake signal. Press a little harder and now it’s lighting up 1/4 of the lights from the center towards the outside edge of the vehicle. And when you’re pressing the brake pedal to the floor, all of the lights are lit up from the center to the outside edges of the vehicle. The harder you press on the pedal, the more lights are illuminated.

Now you have an immediate indication of just how hard the person in front of you is braking. With the normal on/off brake signals, you don’t know what’s happening until moments later as you determine how fast you are approaching that car. They could be casually slowing, or they could be locking up their wheels for an accident in front of them.

I associate it with the fight I’ve had every single time I tried to use it. It’s never been a smooth process on any server I attempted to use it on. Usually I either run into problems with a system not wanting to properly boot the memory stick even with a full UEFI image flashed to it, or if I do get that to work I go through the whole installation process only to find the system unbootable for whatever reason. Eventually I just give up and do a standard installation because why should I have to work this hard to put an OS on a machine?